Open Access Open Access  Restricted Access Subscription Access

SEPIC Converter with High Static Increase for Sustainable power Applications

T. Rajesh

Abstract


In this paper a Solitary Finished Essential Inductor Converter (SEPIC) with high static addition is proposed for environmentally friendly power applications particularly for photovoltaic cell. The benefits of SEPIC are consistent information current and gives steady result voltage despite the fact that the scope of source voltage is huge. Hence this converter is liked to move forward/step down the sun powered charger input voltage. The reproduction results are taken in MATLAB/SIMULINK which shows that a high voltage gain is accomplished. What's more, it likewise accomplishes high effectiveness by lessening the flowing current. The proto sort pack has the evaluated input voltage is taken as 15 V DC, the voltage across the SEPIC converter is 150 V DC at exchanging recurrence 65 kHz and the heap voltage is 150 AC.


Full Text:

PDF

References


Qiao, C., & Smedley, K. M. (2001). A topology survey of single-stage power factor corrector with a boost type input-current-shaper. IEEE Transactions on Power Electronics, 16(3), 360-368.

Huang, N., Zhang, D., Song, T., Fan, M., Liu, Y., & Zhao, Y. (2005, March). A 10 kW single-stage converter for welding with inherent power factor correction. In Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005.

(Vol. 1, pp. 254-259). IEEE.

García, O., Cobos, J. A., Prieto, R., Alou, P., & Uceda, J. (2003). Single phase power factor correction: Asurvey. IEEE Transactions on Power Electronics, 18(3), 749-755.

Jovanovic, M. M., & Jang, Y. (2005). State-of-the-art, single-phase, active power-factor-correction techniques for high-power applications-an overview. IEEE transactions on industrial electronics, 52(3), 701-708.

Choi, W. Y., Kwon, J. M., & Kwon, B. H. (2008). Bridgeless dual-boost rectifier with reduced diode reverse- recovery problems for power-factor correction. IET Power Electronics, 1(2), 194-202.

Villarejo, J. A., Sebastián, J., Soto, F., & de Jodar, E. (2007). Optimizing the design of single-stage power-factor correctors. IEEE Transactions on Industrial Electronics, 54(3), 1472-1482.

Stepanov, A. (2015, November). Galvanically isolated MPPT DC/DC converter for PV system tied to DC grid. In 2015 IEEE 3rd Workshop on Advances in Information, Electronic and Electrical Engineering (AIEEE) (pp. 1-4). IEEE.

Mukundan, C. N., & Jayapraksh, P. (2017, December). Solar PV fed cascaded H-bridge multilevel inverter and SIMO-SEPIC based MPPT controller for 3-phase grid connected system with power quality improvement. In 2017 National Power Electronics Conference (NPEC) (pp. 106-111). IEEE.

Narula, S., Singh, B., & Bhuvaneswari, G. (2014, December). Bridgeless Single-Ended Primary Inductance Converter with improved power quality for welding power supplies. In 2014 IEEE 6th India International Conference on Power Electronics (IICPE) (pp. 1-6). IEEE.

Lazaro, A., Cobos, J. A., Barrado, A., & Olias, E. (1996, October). Design of a zero-current-switched quasi-resonant SEPIC used as power factor pre- regulator with voltage follower control. In Proceedings of Intelec'96- International Telecommunications Energy Conference (pp. 271-278). IEEE.


Refbacks

  • There are currently no refbacks.