Study of Cutting Tool Wear of PVD Coated Tools in Wet Machining Process
Abstract
Aluminium Al12Si is machined under wet machining conditions. There are two cutting fluids are used namely Neem Seed Oil and Soluble oils. All machining parameters are taken under Mnitab 19 L9 Array. Surface roughness of each tool in each cutting parameter under specific machining parameter is studied and tabulated. Tool wear of AlCrN and DLC coated tools is studied under Scanning Electron Microscope (SEM) and compared both of them under 100X and 250X resolution. DLC coated tool shows less wear compared with AlCrN coated tool.
Cite as
Anil Waghmode, Sanjay Pawar, & Sahebagouda Sanganagoudar. (2022). Study of Cutting Tool Wear of PVD Coated Tools in Wet Machining Process. Research and Development in Machine Design, 5(3), 1–5. https://doi.org/10.5281/zenodo.7334166
Full Text:
PDFRefbacks
- There are currently no refbacks.