Open Access Open Access  Restricted Access Subscription Access

Experimental Investigation on Substrate of Steel using Laser and Aluminum Powder

Rahul Sharma


Covering steel surfaces with hard artistic particles in Aluminum has an extraordinary impact to improve mechanical properties and wear obstruction. This exploration examined direct laser affidavit, where no cover is utilized, of unadulterated Aluminum and its composite powder with SiCp of 30% and Mo2C 30% are led, applying laser cladding strategy (LC) utilizing coaxial cladding spout. The impacts of SiCp and Mo2C content in composite and the laser preparing parameters in particular; laser intensity of 900 to 1200-watt, filter speed of 0.9 to 1.1 m.min-1 on clad layer arrangement and its geometry are examined. Results demonstrate that the clad geometry parameters show signs of improvement quality clad layer with the expansion of laser vitality thickness to get full clad layer at vitality thickness 25.6 A few parameters, for example, width , entrance , viewpoint proportion and weakening rate are straightforwardly corresponding to laser vitality thickness. While stature on the opposite side is contrarily relative to laser vitality thickness due to keeping up encouraging rate steady. A slight increment in clad geometry parameters was seen in Al-SiC cladding layer over Al-Mo2C.

Full Text:



  • There are currently no refbacks.